Locknetics Maglock Wiring Diagram

This manual covers the complete installation and wiring instructions for the following. GF .

Make final wiring connections (see Wiring Diagram: on page LOCKNETICS. M I MN MORTISED MAGNETIC LOCK.

INSTALLATION AND WIRING INSTRUCTIONS. Birch Street, Forestville, CT.

Wiring should be protected by conduit. Wire leads provided Other sex nuts, of different lengths, are available from Locknetics distributors. Refer to the last page Slide the TJ mounting plate onto the magnetic lock assem- bly.

Center it and. with a mechanical latching device, in addition to the magnetic lock, in accordance With optional access control input devices (Locknetics keypads or iButton readers) the locks This manual covers the mechanical installation, wiring, and manual Count the number of flashes and refer to the chart below for diagnosis.

jurisdiction. Locknetics manufactures fire rated mechanical latching devices. ers the mechanical installation, wiring, and manual programming aspects of the locks.

The magnetic lock uses significantly less current so more locks can be loaded onto a power supply. ..

Magnetic Lock Kit Wiring Instructions

(See chart on page 20 “Table of Outputs”.) LED.Electromagnetic Locks. The broad portfolio of Allegion’s electromagnetic locks offers a solution for most every application.

Whether it’s securing a hospital laboratory, monitoring a controlled area in an airport or providing traffic control for doors in an institutional building, Schlage magnetic door locks are designed for both unique applications and specification.

– WIRING INSTRUCTIONS— Magnetic lock or fail safe strike with button, keypad, maintained button and remote receiver.

wired in series Power Supply for fail safe strikes and magnetic locks should be DC. If this is not available you may use an AC power source and wire inline a “Full Wave Bridge” rectifier.

This will conver t the AC to DC. INSTALLATION INSTRUCTIONS NARROW LINE EMLOCK Electrical Instructions: Use properly fused U.

L. Listed Power Supply Do not install a diode in parallel with any magnetic lock.

A diode will cause a delay when releasing the door and residual magnetism to occur. Access controls and/or release contacts must be located in series.

M Series Electromagnetic Lock. The M Series offers 16 models that are designed to make quick, light work of installation with a bayonet mounting bracket and slide-together components for easy in-field handing and wiring. Pass control/monitoring wiring through wire access hole in frame and through wire hole in mounting bracket.

Mount bracket using pan head screws and flat washers.

Do not completely tighten screws – it will be necessary to adjust the position of the bracket in step 5. OUTSWINGING MAGNETIC LOCK with AVS INSTALLATION INSTRUCTIONS.Remote Control Transmitter & Receiver Set (Great For Access Control)Electromagnetic Locks